欢迎访问济南科尔超声波设备有限公司网站!

专注生产工业用清洗设备

让工业清洗无难事

电话

业务咨询电话:

18663767799

你所在位置: 首页-新闻动态-新闻资讯-低温废水回收设备的维护方法
新闻资讯

低温废水回收设备的维护方法

作者:guanli来源:http://www.jnthcsb.com/时间:2022-11-29

低温废水回收设备的维护方法您知道包含哪些内容呢?这一问题在设备使用期间需要多加了解的,不然非常容易会因为某一细节没做好而导致问题存在。
What do you know about the maintenance methods of low-temperature wastewater recovery equipment? This problem needs to be understood more during the use of the equipment, otherwise it is very easy to cause problems because some details are not well done.
一、每天上班时检查生活低温废水回收设备进污水泵和回流泵是否结冰,包括水泵的润滑加油,填料的松紧,底阀的密封比空压机的加注机油等。
1、 Check whether the sewage pump and reflux pump of the domestic low-temperature wastewater recovery equipment are frozen at work every day, including the lubrication and oiling of the water pump, the tightness of the packing, the sealing of the bottom valve and the oiling of the air compressor.
二、检查空压机空气滤水伐有无上冻,以判断空压机正常运转,有无杂声及发热现象。
2、 Check whether the air filter valve of the air compressor is frozen to judge whether the air compressor operates normally and whether there is noise and heat.
三、检查刮渣机的传动部分及刮板,在寒冷状态下是否变硬折断,以免影响使用。
3、 Check whether the drive part and scraper of the slag scraper are hard and broken in cold state, so as not to affect the use.
低温废水回收设备
四、注意混凝剂搅拌储存罐避免结冰,并经常做小样试验。
4、 Attention shall be paid to avoid freezing in coagulant mixing storage tank, and sample test shall be conducted frequently.
五、对各设备阀门管路进行检查以免阀门管路有堵赛、并按要求分别置于“开”或“关”的位置。
5、 Check the valves and pipelines of each equipment to avoid blockage of valves and pipelines, and place them at the "on" or "off" positions as required.
六、停机时须将水放干净,以免发生结冰堵塞。
6、 During shutdown, the water must be drained to avoid icing and blockage.
低温废水回收设备的维护方法从6点讲解完毕,您对此有什么不懂得地方可以随时来我们网站www.jnthcsb.com进行联系了解!
The maintenance method of low-temperature wastewater recovery equipment was explained at 6 o'clock. If you don't know anything about it, you can contact us at www.jnthcsb.com at any time!