欢迎访问济南科尔超声波设备有限公司网站!

专注生产工业用清洗设备

让工业清洗无难事

电话

业务咨询电话:

18663767799

你所在位置: 首页-新闻动态-新闻资讯-CNC高压清洗机日常操作与使用说明
新闻资讯

CNC高压清洗机日常操作与使用说明

作者:guanli来源:http://www.jnthcsb.com/时间:2022-11-25

高压清洗机的冲洗能力强,能去除地面等物体表面的污垢与油污渍等。小编特地整理一份高压清洗机的使用说明,方便大家随时随地查询。高压清洗机的使用说明如下:
High pressure washing machine has strong washing capacity, and can remove dirt and oil stains on the surface of objects such as the ground. I specially compiled a manual for the use of high-pressure cleaning machine, which is convenient for you to inquire at any time and anywhere. The operating instructions of the high-pressure washer are as follows:
1、接好高压清洗机的电源开关;
1. Connect the power switch of the high-pressure washer;
2、通电时,主要要把喷枪打开,避免出现回流水现象和机器发热;
2. When the power is on, the spray gun should be turned on to avoid backflow water and machine heating;
3、初次使用高压清洗机时,使用够20个小时后更换机油(机油用摩托车机油就可);
3. When using the high-pressure washer for the first time, change the engine oil after 20 hours of use (motorcycle engine oil is enough);
4、第二次以后,使用100个小时后更换一次机油;
4. After the second time, replace the engine oil after 100 hours of use;
5、冲洗时,压力慢慢加大,不要一次加到大,以避免机器发热;
5. During flushing, the pressure shall be increased slowly, not at one time, to avoid heating of the machine;
6、冬天使用时,注意要涂防冻液;
6. When using in winter, pay attention to applying antifreeze;
7、加机油时,注意加油量,加到油缸规定红线稍高就可;
7. When adding oil, pay attention to the amount of oil, and add it to the specified red line of the oil cylinder slightly higher;
8、冲洗时,切忌将水枪对着人,以避免伤人;
8. When washing, never point the water gun at people to avoid injury;
9、间歇式冲洗时,停枪的时间不要超过2分钟,以避免回流、机器发热;
9. During intermittent flushing, stop the gun for no more than 2 minutes to avoid backflow and machine heating;
10、停机时,注意先关电源。
10. When shutting down, turn off the power first.
CNC高压清洗机日常操作与使用说明的相关内容我们就讲解到这里了,您对此有什么想咨询的问题就来我们网站www.jnthcsb.com咨询看看吧!
This is the end of the daily operation and use instructions of the CNC high-pressure washer. If you have any questions, please come to our website www.jnthcsb.com for consultation!